EMF-7394.1 OVERSIZE Upper Ball Joint Assembly SINGLE 2000-02 Dodge Ram

Oversized Upper Ball Joint Assembly. Comes as a single upper ball joint with 1/4-28 straight grease fitting. This is an OVERSIZED ball joint.

**THIS IS A SINGLE OVERSIZE UPPER BALL JOINT**

Oversize Housing = 1.905"

This fits: 

2000-2002 Dodge Ram 2500/3500

EMF Dodge Ram **OVERSIZED** 00-02 4WD Upper Ball Joint (SINGLE)

FITS:  2000-2002 Dodge Ram 2500/3500 4WD

Oversized Ball Joints are for those who have changed theirs out more than 3 times, have Moog Problem Solver Knurled Body Ball Joints in there currently, or the knuckle holes have been stretched out.  The OD of the body has been machined larger to accommodate the looser knuckle hole.

What if you could replace your ball joints once and never have to press the ball joint out of the knuckle ever again?

If you’re looking for something LONG LASTING, REBUILDABLE and GREASEABLE, you have come to the right place.

What is Included in the EMF Ball Joint Kit?

• 1 Single Oversized Upper Ball Joint
• Install Nut
• Instructions & an EMF Sticker

Upper Ball Joint Installation Cup and Spanner Wrench are sold separately.

HOUSING MEASUREMENTS:

EMF UPPER BALL JOINT OVERSIZED BODY SIZE – 1.905” (+.001)

Upper Ball Joint is a KING PIN (Telescopic) right from Dodge.  The pin is supposed to move up and down! This is Normal and does not indicate play in the joint.

What makes EMF different than the other Rebuildable Ball Joints on the market?

• As the years go by and miles are put on the truck and normal wear and tear happen, the Internal parts of the Ball Joints will also begin to wear. If, at any time, you start to feel Up and Down Play in the Lower Ball Joint, you simply take the set screw out of the side of the housing and tighten the Ring, then put the set screw back in, grease and you’re good to go!
• EMF Ball Joints are TRULY REBUILDABLE – Which means inside the Ball Joint housing there is a removable race and pin. This removable race acts as the wear point inside the housing, protecting it from any damage.  When the time comes to rebuild the Ball Joint, there is no need to press the housing out of the knuckle.  You simply rebuild the Ball Joint right on the truck by removing the set screw on the side of the body, then removing the Threaded Ring or Cap using a Spanner Wrench.  Finally, you pop the internal race(s) and pin out and put the new ones in, tighten up the Ring/Cap, put the set screw back in and grease!  Saving you Time and Money.
•  EMF is a Canadian Company, which means we need parts that last in all sorts of extreme temperatures. EMF Ball Joints are manufactured by us in our humble shop in Alberta, Canada.  EMF Ball Joints are made from 4140 HTSR Chromoly Steel and then they go through a process called QPQ Salt Bath Nitriding and this is what gives the material added strength and the smooth, long lasting, anti-galling black finish.

• We don’t believe customers should have to pay an arm and a leg for good parts so we try to keep costs as low as we can while keeping the quality as high as we can offer.

The Install Tool for the Upper Ball Joint is to avoid damaging the Cap when pressing the ball joints into the knuckle using a suitable Ball Joint Press. IT IS SOLD SEPARATELY. Pics below show how the Installation Cup is used on the Upper Ball Joint: